Model NO.
G3-T0.2
Hardness
Soft Tooth Surface
Installation
Oscillating Base Type
Step
Single-Step
Type
Worm Gear Box
Color
Blue/Silver White
Output Speed
14-280r/Min
Input Speed
1400rpm
Oil Seal
Nak Oil Seal
Power
0.1kw-2.2kw
Transport Package
1 PC/Carton; Several Cartons/Wooden Case
Specification
0.7kg~~80kg
Trademark
Chenxin
Origin
China
HS Code
8483409000
Production Capacity
30000pieces/Month
Application:
Motor, Electric Cars, Motorcycle, Machinery, Marine, Toy, Agricultural Machinery, Car
Function:
Distribution Power, Clutch, Change Drive Torque, Change Drive Direction, Speed Changing, Speed Reduction, Speed Increase
Layout:
Cycloidal
Technical performance and selection reference| Normal Ratio | 5 | 10 | 15 | 20 | 25 | 30 | 40 | 50 | 60 | 80 | 100 | 100 | 120 | 160 | 200 | ||
| 0.2kw | output speed ratio | Φ18 | Φ22 | Φ28 | |||||||||||||
| actual speed ratio | 4.97 | 10.12 | 15.16 | 20.08 | 24.89 | 30.21 | 40.55 | 50.32 | 60.75 | 80.77 | 100.23 | 104.08 | 120.88 | 161.07 | 196.43 | ||
| n2(r/min) | 282 | 138 | 92 | 70 | 56 | 46 | 35 | 29 | 23 | 17 | 14 | 13 | 12 | 9 | 7 | ||
| M2(NM) | 6.5 | 12.6 | 19.1 | 26.3 | 32.6 | 38.9 | 50.4 | 63 | 75.6 | 100.8 | 103.9 | 125.4 | 150 | 200.4 | 250.7 | ||
Note recommendationsTo install the reduction unit it is necessary tonote the following recommendations:
1. Check the correct direction of rotation of thereduction unit output shaft before fitting the unit tothe machine.
2. Before mount with the prime moveanddevice,please check the reducers every axiadiameter, aperture,key and key slot,
to be theirdimensions are not deviation, and avoidassembaurtoo tight or too loose, unless it wilinfluence the reducer's performance.
3. The mounting on the machine must be stableto avoid anv vibration.
4.Whenever possible,protect the reductiorunit against solar radiation and bad weather.
5.In the case of particularly lengthy periods ofstorage (4-6 months), if the oil seal is not immersedin the lubricant inside the unit.
It is recommended tochange it since the rubber could stick to the shaft ormay even have lost the elasticity it needs to functionproperly.
6.Painting must definitely not go over rubberparts and the holes on the breather plugs, if any.
7.When connect with hollow or solid shaftplease grease the joint to avoid lock or oxidation.
8.Check the correct level of the lubricantthrough the indicator, if there is one.
9. Starting must take place gradually, withoutimmediately applying the maximum load
10. Supporting unit is required when usingvarious of reducer matched with motor directiy andthe wsight of motor is a little bigger than common.
11 .Ensure the motor cools correctly byassuring good passage of air from the fan side.
12. In the case of ambient temperatures<-5°Cor>+40°C call the Technical Service.
Send Message
