Gas station cut-off valve(emergency shut off valve,emergency shut valve)
Characteristic
Use:the emergency cut-off valve is installed on the inlet of the pipeline for the submersible pump type fuel dispenser. In case of accidents, for instance, the dispenser collapsing or a fire, the valve can rapidly cut off the oil flow automatically.
Installation: install the oil pipeline with oil-proof pipes which will not turn hardened, The screw seal adopts thread sealant. The tightness should not be excessive. Don't screw on the slot, or else the valve will be twisted off. Fix the hexagonal screw on the top of the valve with a spanner and screw the joint with another spanner . The slot must be on a level with the top of the base or within 10mm above or below. Otherwise, the slots on the inlet and outlet are possible to be broken off caused by the heavy strike.
Change of the top slot: Shut off the power supply for the oil pump and oil drainage system. Manually close the valve, take off the hexagonal screw, pull out the valve top, take down the gasket, spread butter on, mount a new valve top and tighten the hexagonal screw.Change those parts with even slight damages. Load the pipes in the oil distributor again and check whether there is any oil leakage.
Valve maintenance: Open and close the valve manually several times and restore to the former position again to confirm whether the valve can operate normally. Such operation must be conducted annually to check whether there are any damage to the valve and whether repair is necessary or not.
Technical Specification
| Main Part Material | dust casting iron |
| Nominal Pressure | 0.2MPa |
| Threaded Joint of the Inlet and Outlet | NPT 1.5'' |
| Flow Range | 120L/min |
| Operating Medium | gasoline, diesel, coal oil |
| Operating Environment | -20°C-+55°C |
| Rate of Valve Closure | 0.5S |
Body Length | 510mm |
Upper Drop size | DN 100mm |
upper coupling | male coupling |
Spill Container For Gas Station
Spill Container is to collect the leakage fuel when rhe tanker is loading .the cover is carbon steel material ,the body is toughness .the body is installed in the sand which can efficiently protect the outside influence to avoid the leakage of the container .Unique and reasonable design to make it afford the weight of the tanker driving on it .there is a drain valve ,when pull this valve ,it will release the inside fuel go back to the underground tanker .
Technical Information
| Type | Spill Container For Gas Station |
| Size | 4 " |
| Material | Plastic + Carbon Steel |
| Pressure | 0.6Mpa |
| Open Mode | Manual |
Features
Spout retaining ring - adds extra measure in securing nozzle spout in fill pipe
Helps reduce spills - a unique two-stage lever design assures a positive shut-off, even if held wide open
Design Working Pressure - products are designed to work at 50 PSI maximum pressure
Easily replaced spout - simply remove three screws. Replacement kits are readily available from
Dash-pot action - for smoother closing action and reduced line shock
Dual poppets - easy to open nozzle against high pressure
FlowLock™ - designed to shut-off automatically when the spout is tipped up, limiting spillage
Low reliable shut-off - specially designed to ensure proper shut-off as low as 5 gallons per minute
Even, smooth spray pattern - minimizes diesel foaming and false shut-offs
