Drive-Through Powder Coating Spray Booth Loading to Kenya

Drive-through Powder Coating Spray Booth Loading To Kenya
equipo de pintura        malowanie proszkowe stoisko        cabina di verniciatura a polvere


Industrial Automatic Spray Booths easy operation with good powder recovery systems.
our customer of Kenya buy 1 Drive-through powder spray booth,curing oven 1pcs,powder sieve etc.
 
Booth size and color can be designed by the requst.

1.Specification:
1).Spray booth:
1.inner size: 620width x 1500 height x 2920 depth
2.Booth board: SPCC/= 1.5mm Bending and forming
3.Under frame:4 # square tube
4.Recycle Filters:325*900mm- 3pcs
5.fan motor: 3.5KW, 1pcs
6.manual powder coating gun ,1pcs

2.)Technical data

Model	COLO-S-3212
Booth Type	drive-thru
Operator dimensions	620width x 1500 height x 2920 depth (2PCS)
Overall dimensions	1200width x 2033 height x 3000 depth
Weight	500kg
Power supply	Electric
Nominal power	3.5kW
Voltage	380V
Frequency	50-60Hz
Filters	Polyester
Filters count	3
Filters hang type	easy for change
Filter cleaning system	Pneumatic
Warranty	12 months

3).Advantage:
1.applied for thin workpiece.
2.Working with manual gun
3.Smooth interior, easy to clean.
4.the control and monitoring of each active component can be individually regulated, ensuring better service life for pneumatics and electrics.
5.Short powder cycle, safeguards the powder.
6.Energy saving air circulation, the extracted air is fed back into the paint shop.
Also economical in mixed powder mode for individual colours.

4).Replacing the filter cartridges Replacing the filter cartridges
Procedure for replacing the filter cartridges
If a filter cartridge is damaged, but the damage can not be found, then the complete filter
cartridges set must be replaced. The access to the filter
cartridges takes place from the rear of the booth
 

Dismantling:
1.fix the screw on the top
2.Hold the cartridge with both hands, so that the filter's six ears for quick release cover six corresponding gap
3.His hands up top, while the rubber ring as a fulcrum to sixty degrees clockwise
4.Check the filter is fully embedded in the quick release cover, hand gently pulled the filter is securely

5).Control cabinet-Bottom:
1,power on/off
2,hopper go up/go down
3, emergency stop
PLC Controller Operation:

1.press  bottom 1 ,make the power on

2,Press ↑or↓ ,make the display screen display like this

3,Press F4 ,then into the booth control interface like this

4,Press F6,then the fan will on ,like this

When you want to stop the work, please press F6 ,make the fan off, like this
Then press the bottom 1 to make the power off.
In the side of the booth have the switch to control the light lamp