XK-300
Submersible
Contact
Switching Type
Normal Wirewound
Corrosion Resistant
Stainless Steel
IP65
ISO
Customized
<2MPa
-20-300ºC
Flange ,Thread
Customized
Nc, No ,Spdt
24VDC/220VAC
IP65
up to 4MPa
Aluminum
M20*1.5 & Customized
Solid and Liquid
U-ideal
Wooden Case or Carton
220VAV/24VDC
Tianjin, China
90261000
Product Description
Tuning fork level switch for solid, vibrating rod level switch Tuning Fork Switch vibrates to tuning fork by piezoelectric crystal and inherent frequency of tuning fork.It can monitor continuously to the change of frequency.
When the tuning fork switch is used for low alarm (or low position control), the medium in the vessel is discharged downward passing through the tuning fork.When it is lower than the specific location and change the inherent frequency, this change is detected by electronic component, the output state is shifted; when it is used for high alarm (or high position control), the medium in the vessel go upward and contact with tuning fork which can shift the output state. changes, these changes are detected by the intelligent circuit, and converts it into a switch signal.
Tuning fork level switch Application:
Whatever feed,mud and drike or pulp,glue and dye.the level switch is suitable
Water, mineral water
Waste water, sewage, slurry, acid alkali solution
Beer, beer starter culture, juice, beverage
Paper pule, glue,dye,solid power and other similar good mobility materials
Diesel and other similar dangerous liquids/ hazardous conditions
Features:
High adaptation: no influence on electrical parameter and density of medium, suitable for various conditions. Scaling ,stir, turbulent flow, bubble ,vibration, middle viscosity, high pressure, high temperature etc.
No calibration: no need for calibration on spot since no impact on electrical parameter and density of medium
Maintenance-free: no moving parts, no need to maintain after installation.
Various Power supply: he vibrating fork level switch is 20~250VAC, 20~60VDC,Suitable for all Power supply place.
Various Connection: The level switch with flange and thread connection for you reference.
| medium temperature | -20ºC-150ºC |
| mesured medium | liquid, powder or granular solid |
| measured medium density | solid≥0.1g/cm3 liquid≥0.7g/cm3 |
| measurd solid particle size | ≤10mm |
| Maximum liquid viscosity: | <1000mm2 /s |
Connectionmethod | G1",thread:G3/4,thread:1"NPT |
Forkbodymaterial: | SS304,SS316 stainlesssteel,PTFE |
Enclosureprotection class | IP65 |
Power supply voltage | DC24V:AC220V 50HZ |
electricalinter face | M20*1.5 |
0utput signal | relayoutput:8A220VAC;8A24VDC |
