BS24126050
24V-310W
12V/6A
12-24/12V
Lead-Acid Battery Charger
Solar Charger
Half-Bridge Charger
12V
Gel, Sealed, Flooded, LiFePO4, Lithium-Ion
24V
Lead-Acid
60A
50A
50V
18mA
190*215*77mm
1.6kg
Oxiang, OEM
Neutral
neutral
Shenzhen
Product Description
DC-DC Battery charger B2B inverter MPPT solar
Features
24V-12V Dual input DC & Solar Battery charger support Bluetooth, Free APP and Meter,Automatic smart vehicle charger,Battery to Battery
1.Input voltage:24V, Output voltage: 12V
2.B2B charge: 12V 60A
3.MPPT solar: 12V 50A;Pvmax:685W
4.Charge Battery type:GEL,Sealed,Flooded,LiFePO4,Lithium-ion
Choose Accessories: Monitor(MT-2); Bluetooth Dongle(BT10); Temperature Sensor(TRS)
Technical Data
BS24126050 | |
Main battery "BOARD I" | |
Lead-Acid, Gel, AGM Batteries Nominal Voltage | 12V |
LiFePO4 Nominal Voltage | 12.8V |
lithium-ion(NCM) Nominal Voltage | 11.1V |
Capacity (Battery Size), recommended | 100-520AH |
Battery voltage range | 8V-16V |
Vehicle Starter Battery "Start II" | |
Vehicle Starter Battery Nominal Voltage | 24V |
Capacity (Battery Size), recommended | 80-100AH |
B2B Charging operation | |
Start battery voltage range | 21~32V |
Max.charge power | 780W |
Max. chrge current | 60A |
"D+" signal voltage | 16-32V |
MPPT solar charge controller (only BS series) | |
Max. PV power | 685W |
Max. PV charge current | 40A |
Max. Open circuit voltage | 50V |
Board I Max.charge current | 50A |
PV charges the start battery | no function |
Temperature compensation | -3mv/ºC/2V |
"TR"signal | NC |
Main battery temperature sensor"T T" | YES |
Main battery voltage detection"SS-,SS+" | YES |
Stand-by current | 32±2mA |
Weight | 1.6kg |
Operating temperature | -20-50ºC |
Demension | 190×215×70mm |
Further Characteristics of the Unit
- The output voltage is stabilized, free of peaks, smoothed and filtered.
- Galvanic isolation between input and output:
- No overvoltage at the output and thus protection of the consumer if the ground line is lost.
- Clean, undisturbed mass ratios, even with long supply lines.
- Stable operating voltage on site in mobile operation, e.g. Containers, trailers, roll containers etc.
- Filtering and suppression of disturbances on the input to the output side.
- Fully automatic continuous operation: The DC-DC converter can constantly work with the battery
- Surveillance-free operation: multiple protection against overload, overheating, over voltage, short circuit, Misconduct and deep discharge of the battery through electronic regulation to complete
- Switch off by built-in safety switch.
Function
Security guidelines
Intended use:
The DC-DC converter was built on the basis of the valid safety guidelines. The use may only be:
- On lead-acid, lead-gel or lead AGM or LiFePO4 batteries of the specified nominal voltage.
- With the specified cable cross-sections for inputs and outputs.
- With fuses of the specified strength near the battery to protect the wiring between the batteries and DC-DC converter connections.
The device must never be used in places where there is a risk of gas or dust explosion consists!
Installation of the Unit
- . Install the charger near the board supply battery I (for short charging cables) at a clean, even and hard mounting surface,which is protected from moisture, humidity and aggressive battery gases. The unit can be installed in any position.
- . To be installed in a moisture-proof, water-proof place, corrosion-proof place
- . When the charging controller is working, the fan will bring out heat, so when installing, ensure that there is at least 10cm of space behind the charger controller
- . Choose the appropriate cable specifications, length and fuse specifications, reverse connection of the battery will cause serious damage to the equipment
Why Choose us?
> Oxiang is located in Shenzhen, China, a new type of city in rapid development. We focus on CCTV Camera researching and manufacturing from 2006;
> Sales person provide Pre-sales and after-sales service; Professional engineers are always standby and assist offer solutions;
> Cooperate with multiple departments to complete raw material procurement, production, inspection, delivery and other steps;
> The product comes with a one-year warranty.
