MEVS Series
Integration
Analog Sensor
Hall Wheel Speed Sensor
Metal
Free Replacement
3 Years
Yuanben
Hall Sensor
Vehicle Speed Sensor, ABS System
Yuanben
Carton
Shanghai
Product Description
Yuanben Locomotive Engine Rotatory Speed Sensor
Description
GVS Series Tooth Sensors use a magnetically biased Hall effect integrated circuit to accurately sense movement of ferrous metal targets. This specially designed I.C., with discrete capacitor and bias magnet, is sealed in a probe type package for physical protection and cost effective installation.
Output is digital, current sinking (open Collector). Reverse polarity protection is standard. If power is inadvertently wired backwards, the sensor will not be damaged.
Optimum sensor performance is dependent on the following variables which must be considered in combination:
Features
Typical Applications
Automotive and Heavy Duty Vehicles:
Specifications
Photos
Description
GVS Series Tooth Sensors use a magnetically biased Hall effect integrated circuit to accurately sense movement of ferrous metal targets. This specially designed I.C., with discrete capacitor and bias magnet, is sealed in a probe type package for physical protection and cost effective installation.
Output is digital, current sinking (open Collector). Reverse polarity protection is standard. If power is inadvertently wired backwards, the sensor will not be damaged.
Optimum sensor performance is dependent on the following variables which must be considered in combination:
- Target material, geometry, and speed
- Sensor/target gap
- Ambient temperature
- Magnetic material in close proximity
Features
- Senses ferrous metal targets
- Digital current sinking output (open collector)
- Better signal-to-noise ratio than variable reluctance sensors, excellent low speed performance, output amplitude not dependent on RPM
- Sensor electronically self-adjusts to slight variations in runout and variations in temperature, simplifying installation and maintenance
- Fast operating speed - over 100 kHz
- EMI resistant
- Reverse polarity protection and transient protection (integrated into Hall I.C.)
- Wide continuous operating temperature range
Typical Applications
Automotive and Heavy Duty Vehicles:
- Camshaft and crankshaft speed/position
- Transmission speed
- Tachometers
- Anti-skid/traction control, ABS system
- Sprocket speed
- Chain link conveyor speed and distance
- Stop motion detector
- High speed low cost proximity
- Tachometers, Counters
- Gear tooth Sensor
Specifications
- All values were measured using 1 K pull-up resistor.
- Electrical Supply Voltage 4.5 to 24 VDC
- Output Voltage (output low) 0.4 V max.
- Output Current (output high) 10 µA max. leakage into sensor
- Switching Time Rise (10 to 90%) 15 µsec. max.
- Fall (90 to 10%) 1.0 µsec. max.
- Absolute Supply Voltage (Vs) ±30 VDC continuous
- Maximum Voltage Externally Applied Ratings To Output (output high) -0.5 to +30 V
- Output Current 40 mA sinking
- Temperature RangeStorage -40 to 150°C (-40 to 302°F)
- Operating -40 to 150° C (-40to302°F)
- Switching Operate Point 3.7±1.25° (3,28±1,13 mm)
- Characteristics Release Point 4.7±2.50° (4,16±2,21 mm)
- Differential Travel 8.4±3.70° (7,45±3,34 mm)
Photos
