Main Feature
1. Independent research and development ability, software upgrade continuous (software function, interface design and database upgrade)
2. Imported camera lens with high quality.
3. Non-contact, avoid damage to aluminum rim.
4. Voice prompt function makes the operation convenient.
5. Intellectual property is one of our development value and will realize max. profit.
6. All the components are made from moulds, can be installed or replaced at will.
7. The software function and interface can be designed at customers' demand.
8. The promoter elements under warranty for lift,low price in using.
9. HD target board can realize interaction without calibration.
10. With vehicle and customer search function,quick and convenient in searching.
11. Pure homemade 3D four wheel alignment tester,hight precision in measurement.
Product introduction 7075.
Guan Jian pieces of this product: the camera and the lens using SONY technology, reflective board without any electronic original device, its rear cover using 7075 aerospace aluminum alloy material production.
:
The main technical parameters are as follows:
| Location parameter | Accuracy (center value) | Precision range | Maximum measurement range |
| Display accuracy and measurement accuracy | ±0.01°/0.01mm | Measurement accuracy of 0.01 degrees or 0.01mm | |
| Toe | ±0.02° | ±0.01° | ±30° |
| Dip angle | ±0.03° | ±0.01° | ±30° |
| Inclination angle of main pin | ±0.03° | ±0.01° | ±15° |
| Inclination angle of main pin | ±0.04° | ±0.01° | ±20° |
| thrust angle | ±0.02° | ±0.01° | ±6° |
| Maximum turning angle | ±0.02° | ±0.01° | ±30° |
| Withdrawal angle | ±0.02° | ±0.01° | ±6° |
| Tread | ±0.25cm | ±0.01° | 3000mm |
| Wheelbase | ±0.25cm | ±0.01° | 8000mm |
| Diagonal money | ±2mm | ±0.3cm | 12000mm |
| Rolling radius | ±2mm | ±0.3cm | 700mm |
Main feature
-- 3D digital camera measurement system: two 3D digital cameras, four targets
-- Target Features: There is no electronic components on the target, without data transmission,
-- no batteries facilitate the complete elimination of circuit failure. The product is more stable
-- Equipment Calibration: Equipment calibration is done once only when the installation is complete, which is not necessary to regularly repeat.
-- dynamic measurement: dynamic measurement based on pushing. Without raising its body, the vehicle is at a natural state. Simultaneous detection of four wheels would reduce measurement time and improve the accuracy.
Software system: simple operation, to read the basic wheel alignment data within two minutes.
-- Low demand for horizontal level of lift: for the list, the levelness difference of 5cm or less has little impact on the measurement results, different from the traditional technology with over-reliance on gravity optical platform levelness degrees.
-- all-model measurement: it can detect long body, low chassis
.
